Rv toilet not holding water

Thanks for visiting the RV Repair Club site and the opportunity to assist with your toilet issue. Depending on the model and year, your toilet valve will either have a flat “spade” valve that is a piece of flat plastic that slides back and forth into a rubber gasket that is supposed to seal and hold water , or a rounded valve in the newer style. RV Toilet Seal not Holding Water.

This is a common problem that happens to a lot of RV owners. If it happens to you, you are not alone and you may find quite a few remedies out there to help you.

One trick you can use is olive oil. Sometimes the seal dries out and needs a little lubrication to get it working again. It slowly drains out. I might be wrong, but it looks like the ball is not going back the whole way to seal it off correctly. I also checked for debris but it looks clean.

The toilet is the kind with the. BUT, recently, even with periodic cleaning, it started leaking.

How do you clean RV toilet? Is your RV toilet leaking? Why is toilet not working? A gloved finger run around the seal will tell you all you need to know. The cleaning task may not be the most pleasant, but one just needs to get down and dirty to get the job done.

Hold the flapper open with your foot on the pedal and get in the grove with a tool to get the crude out. My toilet came with a tool, but the coat hanger or paper clip will do the job. Be real careful not to drop anything into the.

They’re installed above a holding tank, however, rather than over a septic or sewer connection. Like a regular toilet , traditional RV toilets require water to function, either by connecting to an external water supply or your RV ’s water tank. Check this before you tear into your toilet. I recently replaced the seals and still had a problem. Get Amazing Deals on All of Your Outdoor and RV Needs Online or In-Store!

Find Rv Toilet at FindSimilar. Flush the toilet so it enters the tank and let it sit for a few hours.

This water is essential to seal off the waste tank odors preventing them from getting into the rig. If your seal dries out it can start to develop a slow leak draining out the water and causing a dry bowl. If you’re repairing the blade seals, before you reinstall the toilet in the RV , pour a quart of water into the toilet to make sure the new seals will hold water. If you’re replacing the water valve on the back of the toilet , once you have reinstalled the water line, pressurize the water system to make sure the valve doesn’t leak.

Secon the water enters the bowl but does not exit. Both issues are symptomatic of larger problems and rectifying them can be time consuming and unpleasant. Pressure cleaning the inside of the black tank solves the problem.

This can be done with the built in tank wand or an after market wand (if you have a straight flush into the tank). If the leak is coming from behind the toilet unit, check the ½” sealing grommet or vacuum breaker. If the leak starts from under the foot pedal, check the ½” water line connection or water valve. Electronic Operated Toilets There are a several leak points in these toilet bowls that will need to be checked if water is not being retained.

The warm vinegar will slowly seep out of the area that is not sealed. Allow the vinegar to soak on the leaking seal for about minutes. It will dissolve any remaining lime, sediments, tissue, etc.

Turn the water on and check to see if the unit now holds water.