Homemade antenna mount

How to save money with homemade TV antenna? What are the parts of an antenna? It can also be modified to become an antenna rotator, or add another motor to build a two-axis satellite tracker, perhaps for a future project. Any antenna — TV, radio, or whatever — consists of three parts: the element array, the framework, and the mast.

From a performance standpoint the element array is the most. These antennas can be placed indoors to safe guard it from storm and lightning.

They work well to pull in HDTV signals and can be connected to your flat screen TV. Here i show you how to build a drive on tilt over antenna mount from plywood and some hardware from the local box store. Make sure solder joint is shiny. If it is dull, reheat it till thoroughly melted. Solder electrical connector to end of second wire.

Drill hole in Cap to mount SO2flush. Then drill mount holes for mounting screws. UltraNEXUS-HD X offering H. Paying $a month for satellite TV with channels I rarely watched was not in the budget for me.

Simply fix the new TV antenna on the post that formerly held your satellite dish. Many units come with a mounting bracket and U clamps that allow you to mount them on poles or masts of differing diameters. In some cases, the new digital antenna may not fit onto the dish post.

Mount Your New Antenna. Slip a PVC end cap onto each end of the pipe. This will cover the washers and make the antenna virtually waterproof. Your antenna will look something like this: 18.

With the remaining PVC pipe, cut two lengths about 6” long and push each into an end of the 90-degree PVC corner piece. Using steel plate and box section. The drawing to the left (not to scale) shows the base and some of the details of the assembly.

One should be able to obtain the performance profile of any antenna at each frequency across the broadcast spectrum. HF antennas come in a variety of shapes and sizes. This article helps to explain the differences between them.

The world of electronics, antennas and scanner radios can be a new realm of exploration and fun. Building antennas has long been one of easiest ways to experiment with scanner radios. Building an antenna is educational, and having a scanner radio antenna will allow you to keep up with local alerts, crime, and. I used 1″ thin-wall PVC pipe, aluminum tape, and RG-8X coax. The goal here is to put up a cheap, easy, and quick 2-meter antenna that is simple and unobtrusive, but works quite well.

A few items are needed to make an HF dipole for the amateur bands.

These are normally quite easy to obtain, normally for a relatively low cost. Antenna wire: Obviously one of the key requirements for the antenna is the wire itself. Whilst normal insulated copper wire can be use copper stretches very easily, and it will be found that over time.

For maximum reception, stretch the antenna wire out perpendicular to the station you want to listen to. That means if you draw a make -believe line toward the station, you want to lay the antenna wire out degrees to that imaginary line. You can mount the wire at any height, but consider eight feet for safety. Turns out you can make antennas out of anything.

It’s essentially a Mohu Leaf that has been made pretty. Which is why it’s on this list. I came up with what I call the Wonder Stick antenna ! The Wonder Stick is composed entirely of schedule PVC pipe and a piece of copper-weld gauge wire.